History of Asbestos Bans

Regulatory history of asbestos bans

  • In 1973, EPA banned spray-applied surfacing asbestos-containing material for fireproofing/insulating purposes. See National Emission Standards for Hazardous Air Pollutants (NESHAP) at 40 CFR Part 61, Subpart M
  • In 1975, EPA banned installation of asbestos pipe insulation and asbestos block insulation on facility components, such as boilers and hot water tanks, if the materials are either pre-formed (molded) and friable or wet-applied and friable after drying. See National Emission Standards for Hazardous Air Pollutants (NESHAP) at 40 CFR Part 61, Subpart M
  • In 1978, EPA banned spray-applied surfacing materials for purposes not already banned. See National Emission Standards for Hazardous Air Pollutants (NESHAP) at 40 CFR Part 61, Subpart M
  • In 1977, the Consumer Product Safety Commission (CPSC) banned the use of asbestos in artificial fireplace embers and wall patching compounds. (See 16 CFR Part 1305 and 16 CFR 1304)
  • In 1989, the EPA issued a final rule under Section 6 of Toxic Substances Control Act (TSCA) banning most asbestos-containing products. However, in 1991, this rule was vacated and remanded by the Fifth Circuit Court of Appeals. As a result, most of the original ban on the manufacture, importation, processing, or distribution in commerce for the majority of the asbestos-containing products originally covered in the 1989 final rule was overturned.
 See 40 CFR 763 Subpart I.
    
Asbestos Ban and Phase-Out Federal Register notices
    Asbestos-containing products that remain banned
    Examples of Asbestos-containing products not banned (i.e., products no longer subject to the 1989 TSCA ban because it was overturned)
  • In 1990, EPA prohibited spray-on application of materials containing more than 1% asbestos to buildings, structures, pipes, and conduits unless certain conditions specified. See National Emission Standards for Hazardous Air Pollutants (NESHAP) at 40 CFR 61, Subpart M are met.